Read Before Use - ASA Electronics AP-2 Product Introductions

Read before use

■Please read the following notices before use:
It is prohibited to exceed the maximum torque value described in Technical indexes on Page 3; if the
-
torque exceeds rated measuring value by 120%, it will damage interior of tester.
-The battery charger shall not be used for other batteries except NIMH battery, even the battery
(Non-NIMH battery) is produced by its own manufacturer.
-The torque tester shall not be used for measuring of continuous impact tools like pneumatic screw
driver or impact wrench,
-Please refer to instructions on Page 7 for use of battery charger,
-Please use designated product to connect data output port,
-When disconnecting, please bind the data wire well and avoid damaging PIN of connector,
-After test, please switch off power supply,
-Please don't knock or place heavy objects on display panel.
-Avoid excessively internal adjust when in calibration or other occasions.
-Handle with care and avoid heavy falling.
-The torque tester is very sensitive to environment, so avoid use it in following environments:
‧Places where water, oil or other liquids spills
‧Place with vibration, dirt or heat current
‧Outdoor or places where electric spark may occur
‧Environment with high temperature (proper humidity: 20%-65%, proper temperature: 15-35℃)
‧Places with other factors that may damage the torque tester
-The torque tester shall not be stored in environment with high temperature and humidity so as not to
reduce its performance.
:
5
Read before use