Operation - ASA Electronics AP-2 Product Introductions

Operation

■
Selection of Joint for Measurement
Some "joint for measurement" is attached to this product. At the time of measurement of a tool, the joint
-
corresponding to a tool is surely used.
■
ASJ Joint
ASJ joint is used for measurement of an electric driver.
-
In case joint is chosen, tolerance level is checked and it is cautious of exaggerated torque enough.
-
■
ASJ Joint (Coiled-spring compression system)
Model Of ASJ joint
SJ-03(Option)
SJ-10
SJ-50
ASJ-100(Option)
-The bolt omission prevention function was newly carried in joint. By attaching an omission prevention
screw, if a bolt separates from a plinth, it will race, and it does not decompose and trouble is not caused to
work.（However, when it continues racing, a ridge may be worn out and torque value may change.）
Moreover, by wear, the metal fatigue, etc. of a screw, where a spring is closed, it is left, and a bolt may
jump out with the pressure.)
■
Notice for use:
-Do not overload above the measurement range.
-Please check before use: Whether the bolt and bearing parts are greased.
-Please loosen and keep the spring after using the torque meter.
-The suggested used time is around 2500 times (testing), but if it has below problems, please stop using
and exchange the new ASJ Joint.
‧The spring is bent and deformed, the bolt is worn.
‧When there is unusual sound while operating.
Torque range (kgf.cm)
0.2-2.5
1.5-10.0
5.0-50.0
50.0-300.0
12