Installing the left speaker
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the speaker and provides a visual representation of the installation procedure.
Steps
1. Align and place the left speaker in the slot on the system.
2. Replace the single (M1.6x1.8) screw that secure the left speaker to the system.
3. Route the speaker cables through the routing guide and connect the speaker cable to the connector on the system board.
4. Connect the Proximity sensor cable of the left speaker's WWAN antenna module to the RF board.
5. Replace the single (M1.6x1.8) screw securing the Proximity sensor bracket to the plam-rest assembly.
Next steps
1. Install the battery.
2. Install the
WWAN
card.
3. Install the
base
cover.
4. Install the
SIM card
tray.
5. Install the
SD
card.
6. Follow the procedure in
Removing the right speaker
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Remove the
SIM card
4. Remove the
base
cover.
5. Remove the
WWAN
card.
6. Remove the battery.
38
Removing and installing components
After working on your
computer.
before working inside your
tray.
computer.