Jump-Starting - BMW F 800 GT 2015 Rider's Manual

ATTENTION
Plastic washers missing from
painted components.
Paint damage
Fit the plastic washers under
the heads of the screws.
Install four screws 1 on left and
right.
Fairings
1 lb/ft (2 Nm)
Install the seat ( 54).

Jump-starting

ATTENTION
Current too high when jump-
starting the motorcycle
Cable fire or damage to the vehi-
cle electronics
Do not jump-start the motor-
cycle using the power socket,
only via the battery terminal.
ATTENTION
Contact between crocodile
clips of jump leads and mo-
torcycle.
Danger of short circuit
Use jump leads fitted with fully
insulated crocodile clips at both
ends.
ATTENTION
Jump-starting with a voltage
higher than 12 V.
Damage to the motorcycle's
electronics.
The battery of the donor ve-
hicle must have a voltage of
12 V.
Remove seat ( 54).
Remove center fairing panel
( 110).
Do not disconnect the battery
from the onboard electrical sys-
tem when jump-starting the
engine.
First connect positive terminal
of the discharged battery to
positive terminal on the donor
battery with red jumper cable
8
111
z