Table of Contents
Advertisement
4.5. Heat Reflector (separator - heat cutter) Installation Instruction
5. OPERATING INSTRUCTION OF THE DEVICE
MAY CAUSE INJURY AND DAMAGE THE STRUCTURE. READ THE INSTALLATION
AND OPERATION INSTRUCTIONS BEFORE INSTALLING THE HEATER.
A) Check the gas inlet pressure;
Loosen the screw at the gas inlet test point on the Siemens gas valve (1 or 2
turns). Connect the silicone flexible hose to the test point, connect the other end
to the U-Manometer or digital manometer, measure the pressure, check its
suitability according to the pressure previously given in the table.
DN08.05.20Rev 00
THE HEATER SHOULD BE OPERATED AFTER THE GAS LEAK
CHECK.
INSTALLATION OR NOT DIFFERENT TO THE INSTRUCTIONS
Heat reflector is necessary to
prevent damage to the place on
the top of the device.
It is also called heat cut,
separator.
Heat cut is screwed onto the
radiant heater device in the
direction of the arrows as shown
in the picture on the right.
17
www.hosseven.com.tr
Advertisement
Table of Contents
