Summary of Contents for HOSSEVEN HRK-7
- Page 1 HRK15 USER MANUAL HRK-7 / HRK-11 / HRK-18 HRG-7/ HRG-12 DN08.05.20Rev 00 www.hosseven.com.tr...
- Page 2 1839 HRK Model HRG Model INFA-RED HEATING DEVICES and USER MANUAL MODELS: HRK-7 / HRK-11 / HRK-18 / HRG-7 / HRG-12 DN08.05.20Rev 00 www.hosseven.com.tr...
-
Page 3: Table Of Contents
4.5.Heat Reflector Installation Instruction …………………………………………..17 5.OPERATING INSTRUCTIONS OF THE DEVICE ...………………………….....… 5.1.Operation of the device ………………………………………………………………..19 5.2.Device Shutdown ..………………………………………………………………………..20 6.MAINTENANCE and SERVICE ……………………..…………………………………..…...…21 6.1.Regular Maintenance ……………..…………………………………………………….22 7.OPTIMUM INSTALLATION DISTANCES ……….…………………………..………………. 8.SIEMENS VALVE AND CONTROL CARD .……………..…………………………………… 9. TROUBLESHOOTING …..………………………………….……………………………………… 10. WARRANTY……………...………………………………….……………………………………… DN08.05.20Rev 00 www.hosseven.com.tr... - Page 4 • The electrical connection grounding of the device must be done. • This device is produced for outdoor use, well-ventilated spaces or spaces not used for domestic purposes. • Devices installed outdoors must be protected against rain. DN08.05.20Rev 00 www.hosseven.com.tr...
-
Page 5: Important Information And Warnings
Materials under or near the device can be damaged by radiant heat. Wall, floor, furniture, plants etc. affected by extreme heat. objects must be at least 1100 mm from the top and side edges of the device. DN08.05.20Rev 00 www.hosseven.com.tr... - Page 6 Check the device if the following situation has occurred. • 1- If the temperature does not increase in the device • 2- If the burner sounds noise during operation (not the sound coming during the ignition and burning) DN08.05.20Rev 00 www.hosseven.com.tr...
-
Page 7: General Information About The Product
Radiant heaters of Hoşseven brand are designed for effective heating. The heater is equipped with an electronic card controlled by a remote control. NOTE: The device has been designed in accordance with the rules of use outdoors. DN08.05.20Rev 00 www.hosseven.com.tr... -
Page 8: Product Technical Information
2.2.Product Technical Information MODELS HRK-7 HRK-11 HRK-18 HRG-7 HRG-12 Ceramic Stone Piece Power 11.2 Gas type and G20 20 mbar / LPG 30 mbar pressure 0.73 1.14 1.83 0.73 1.14 Consumption kg / h 0.55 0.84 1.37 0.55 0.84 Weight 12.7... - Page 9 Models HRG-7 HRG-12 A (mm) DN08.05.20Rev 00 www.hosseven.com.tr...
-
Page 10: Information Required For Installation
• If some parts of the device are wet, never use them without checking the authorized person. 3. INFORMATION REQUIRED FOR INSTALLATION • In mounting in a well-ventilated area, minimum 25% of the surfaces must be open. • A part of the wall surfaces has been defined as the open area. DN08.05.20Rev 00 www.hosseven.com.tr... -
Page 11: Mounting Distances
• It should not be near combustible materials. • It should not be close to where it can get rain. • It should not be installed indoors. • It should not be installed in places that are not suitable for installation (see pictures below). DN08.05.20Rev 00 www.hosseven.com.tr... - Page 12 Distances to flammable materials Model A (mm) B (mm) C (mm) HRK-7 1100 2500 HRK-11 1100 2500 HRK-18 1200 3000 HRG-7 1100 2500 HRG-12 1100 2500 DN08.05.20Rev 00 www.hosseven.com.tr...
-
Page 13: Installation Instructions
Checks the gas pressure and distribution conditions before assembly. Installation should be done by authorized person. Please learn the weight of the device before assembly and assemble the relevant worker health & safety rules accordingly. DN08.05.20Rev 00 www.hosseven.com.tr... -
Page 14: Device Installation Instructions
4.1. Device Installation Instructions DN08.05.20Rev 00 www.hosseven.com.tr... -
Page 15: Gas Line Installation
The gas valve mounted on the gas pipeline inlet should be the valve that complies with the gas rules. It should be reviewed that all connections are tight and leakage control should be done with soap bubbles. DO NOT LEAK THE OPEN FLAME WITH OPEN FLAME. DN08.05.20Rev 00 www.hosseven.com.tr... -
Page 16: Electrical Connection System
2 A automata. Connection V automat must be 900 mm from the left and right of the device. Electric cables should be kept away from hot surfaces and places where burnt gases are discharged. DN08.05.20Rev 00 www.hosseven.com.tr... -
Page 17: Gas Leak Control
• Re-tighten the leak connection, open the gas and check for leaks again. • Do not smoke during the test. • Continue to check for leaks at other connections. DN08.05.20Rev 00 www.hosseven.com.tr... -
Page 18: Heat Reflector Installation Instruction
Loosen the screw at the gas inlet test point on the Siemens gas valve (1 or 2 turns). Connect the silicone flexible hose to the test point, connect the other end to the U-Manometer or digital manometer, measure the pressure, check its suitability according to the pressure previously given in the table. DN08.05.20Rev 00 www.hosseven.com.tr... - Page 19 The torque (torx 15) screw shown in the gas outlet section number 2 is loosened and the pressure value is measured. While the device is running, the measured value must be the same as the pressure value indicated in the tables. Be sure to tighten the screw back after the measurement. DN08.05.20Rev 00 www.hosseven.com.tr...
-
Page 20: Operation Of The Device
If you can not solve, call the company service. 5.2. Device Shutdown 1. If you are temporarily closing, just turn it OFF with the REMOTE CONTROL 2. If you are closing permanently, turn off the electricity and gas valve. DN08.05.20Rev 00 www.hosseven.com.tr... -
Page 21: Maintenance And Service
The area where the heater is located should be kept away from flammable materials, gasoline or combustible materials. Do not clean the heater with a cleaner or corrosive substances. No special tools are required for service. DN08.05.20Rev 00 www.hosseven.com.tr... -
Page 22: Regular Maintenance
6) Clean the heater's control box, burner, the passages of the circulating air with a strong cleaner or compressed air. Protect the heater against these contaminants. 7) Under salty weather conditions, it is considered normal to have corrosion near the sea places. Check this formation and have it repaired immediately. DN08.05.20Rev 00 www.hosseven.com.tr... -
Page 23: Optimum Installation Distances
It is important to clean and keep the control box, burner and air passages more frequent. Originals of spare parts can be obtained from Hoşseven A.Ş. 7. OPTIMUM INSTALLATION DISTANCES Models A (mm) B (mm) HRK-7 1100 1500 – 3500 HRK-11 1800 1500 – 3500 HRK-18 2500 3000 –... - Page 24 Model B (mm) HRK-7 5000 – 5500 HRK-11 5000 – 6000 HRK-18 8000 – 8500 HRG – 7 5000 – 5500 HRG - 12 5000 – 6000 DN08.05.20Rev 00 www.hosseven.com.tr...
-
Page 25: Siemens Valve And Control Card
• Automatic gas burners comply with CSA standards of flame control and control systems standard. • European standard automatic gas burners comply with EN 298 standard for flame control and control systems. • It can be used in structures thanks to its flame ionization system. 9. TROUBLESHOOTING DN08.05.20Rev 00 www.hosseven.com.tr... - Page 26 1. Adjust the pressure according to pressure low the value shown in the table Ceramic burner 2.Injector blocked surface 2 Clean the injector 3. Burnt gases do not breathe temperature low 3. Provide proper ventilation properly 4.Injector holder from axis DN08.05.20Rev 00 www.hosseven.com.tr...
- Page 27 3.Low gas pressure 2.Clean with brush Carbon forms on 4. Unsuitable gas connected to 3. Set to desired pressure the ceramic on the heater 4.Check the type of gas used with the the surface of the label burner (black) DN08.05.20Rev 00 www.hosseven.com.tr...
-
Page 28: Warranty
3) In case the product fails within the scope of the warranty, if the consumer complies with the conditions specified in the user manual, the device will be repaired free of charge by the Hosseven Authorized Services and the customer will not be charged under any name.