Table of Contents
Advertisement
SECTION 7 –
PLUMBING
Step 1 – Blow Out Procedure
(Drain and purge waterlines using
compressed air)
1. Level the Motorhome. If the motorhome is
not level, there may be "low points" in
waterlines that can trap water in the lines and
prevent it from draining properly.
2. Set the Water Center Panel to the
"winterize" configuration as instructed on
the water center panel (located behind the
passenger rear door). Leave it in this
configuration for the entire winterization
process. The sticker located on the Water
Center Panel shows all of the settings that it
can be configured in.
Water Center Panel in
"Winterize" configuration (Panel
located behind passenger rear door)
-Typical View
3. Turn OFF the Heating System and water
pump by using the control panel (located
near the monitor panel). The water pump
can also be switched off at the Water Center
Panel (located at the top right of the panel).
This switch can be turned off at either station,
for convenience. (The switch at the Water
Center Panel will illuminate if the pump is
on).
7-10
Water heater controls on
Systems Monitor Panel
-Typical View
Water pump switch location
on Systems Monitor Panel
-Typical View
Advertisement
Table of Contents
