Connecting Lp Cylinder And Hose / Regulator To Grill; Lighting Instructions - Brinkmann 2210 Series Owner's Manual

Read, understand and follow all warnings and instructions contained in this manual. DO NOT skip
any of the warnings and instructions contained in the preceding sections of this manual.

LIGHTING INSTRUCTIONS:

Follow the instructions exactly.
1. OPEN THE GRILL LID before attempting to light a burner so that fumes do not accumulate inside
the grill. An explosion could occur if grill lid is down.
2. Check that all burner control knobs and the cylinder valve are turned to the "OFF" position.
3. Turn on the fuel supply by rotating the cylinder valve knob counter-clockwise to full open.
4. DO NOT stand with head, body, or arms over the grill when lighting.
LIGHTING THE MAIN BURNERS:
1. Open lid before lighting burner.
2. Make sure all control knobs are in the "OFF" position.
NOTE: The CENTER BURNER must be lit first, then light the left and right burners.
3. Push and turn the control knob for the CENTER BURNER to the
"HIGH" position.
4. Press the electronic igniter and hold for 3–5 seconds to light burner.
5. If ignition does NOT occur in 5 seconds, turn control knob to "OFF",
wait 5 minutes to allow gas to dissipate and repeat lighting procedure.
6. If the CENTER BURNER does not ignite using the push-button igniter,
wait 5 minutes, see "Match Lighting the Main Burners" section.
7. To light the left and right burners, push and turn control knobs to HIGH.
Follow Step 5.
8. To turn off, turn each control knob clockwise until it locks in the "OFF" position. This does not turn off the
gas flow from the cylinder.
NOTE: If burner does not light or flame is too low, you may have spider or other insect blockage in burner,
or the flow limiting device has been activated. See "Burner Assembly/Maintenance" under Proper
Care and Maintenance, or "Regulator Resetting Procedure" under Connecting LP Cylinder and
Hose/Regulator to Grill.
MATCH LIGHTING THE MAIN BURNERS:
1. Open lid before lighting.
2. Turn the burner control knobs to "OFF".
3. Place a paper match in the end of the matchlighter. Strike the
match and place through lighting hole in the left hand side of the
grill to approximately 1/2" (1 to 2 cm) from the burner.
4. Turn on the FAR LEFT burner control knob to the "HIGH"
position. The burner should light within 5 seconds.
5. If the burner does not light, turn the control knob to "OFF" and
wait 5 minutes for gas to dissipate and repeat lighting procedure.
6. Once lit, light adjacent burners in sequence by pressing in and
rotating the control knob to the "HIGH" position.
7. If the burner does not light within the first few attempts of match lighting, there is a problem with the
gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the
problem is found and corrected. See "Trouble Shooting" section of this manual.
WARNING
WARNING
CENTER BURNER ELECTRONIC IGNITER
GRILL LIGHTING INSTRUCTIONS:
1. Read and follow all warnings 4. Push and turn the control knob for 7. To light the left and right 9. To turn off, turn each
and instructions in owner's the CENTER BURNER to HIGH. burners, push and turn control knob clockwise
manual before lighting. control knobs to HIGH. until it locks in OFF
5. Press the electronic igniter and
Follow Step 6. position.
2. Open lid before lighting burner. hold for 3-5 seconds to light burner.
8. Refer to owner's manual
3. Make sure all control knobs are 6. If ignition does not occur in
for match lighting
in the OFF position. 5 seconds, turn control knob NOTE: Turn off LP supply
procedure.
to OFF, wait 5 minutes to allow gas at cylinder when
NOTE: The CENTER BURNER must
to dissipate and repeat lighting appliance is not in use.
be lit first, then light the left and
procedure.
right burners.
Lighting Hole
Matchlighter
FOR
US
FOR
CALL
10