Control Panel; How To Use; Heating Mode - Supra QUICKFIX 500 Manual

CONTROL PANEL

Standby
Mode selection
M
Open window function
+
Increase function
-
Decrease function
Timer
1 Standby: on/off
2 Heating condition
3 Open window function
4 Comfort mode
5 ECO mode
6 Timer
FITTING THE BASE FEET
(WHEELS):
- To assemble the base feet, place the appliance
face down (fig2)
- Position the base feet on the body of the
appliance.
- Position the base feet on the body of the
appliance using the screws. (Provided with the
appliance).
- Stand the appliance up again so as to check
that the base feet work properly.
- Instructions for use
- Before use:
- Make sure that all products' packaging has
been removed.
- Some parts of the appliance have been lightly
greased. Consequently, the first time the ap-
pliance is used a light smoke may be detected.
After a short time, this smoke will disappear.
- To eliminate the smell given off by the applian-
ce when used for the first time, it is recommen-
ded to have it on at full power for 2 hours in a
well-ventilated room.
- Prepare the appliance according to the function
you wish to use.

HOW TO USE:

- Connect the appliance to the mains.
- The indicator light
- Press to turn on the heater, which is in state
of factory default when first time use.
- Factory default:
- Heating mode: comfort mode
- Target temperature setting: 22 °C
- Date: 1(Monday); Time: 00:00 (Off)
- Window open function: Off
- Timer: Off
- To stop the heater working, press
the heater,
- Unplug the product when it's not in use.
- Clock and day of week setting:
- Press down 3 secs to enter clock and day
of week setting
- The screen display , press + and
choose day from 1-7.
1 Monday
2 Tuesday
3 Wednesday
4 Thursday
5 Friday
6 Saturday
7 Sunday
- Press during few seconds to confirm day
setting and enter the clock hour setting, with
the screen display: .
-
- Press + and to set the current hour
- Press during few seconds to confirm hour
setting and enter the minute setting, with the
screen display: .
-
- Press + and
to set the current minute
- Press to confirm all settings
- Note: The clock and calendar will be reset to
factory default if without power supply.

HEATING MODE:

- Press to enter mode selection. By pressing
M
,heating mode runs in a continuous cycle
M
is on.
to turn off
-
to