1050 And 2050 Series Loggers; Xr Loggers; Tr-1060 Loggers - RBR 1050 Series User Manual

Energizer Kodak
EL123A K123LA
Before changing the batteries, ensure that the logger is not sampling and leave it
idle for at least one minute after disconnecting it from the computer. This will
ensure that it has entered its standby state and its operation will not be disturbed
by removing the old batteries.

1050 and 2050 series loggers

XR loggers

TR-1060 loggers

IEC Procell Duracell Rayovac Panasonic
CR17345 PL123A
Important: RBR data loggers do not have a backup battery. If the
logger has entered its standby state, the clock can run for
approximately two minutes without batteries; however, it will almost
certainly lose a significant amount of time. It is also quite possible
that the clock will reset. We strongly suggest that the logger be
programmed after the batteries have been changed.
To remove the batteries, first open the
are held within their casing by the force of a single spring.
Press firmly upon the negative end of the battery furthest
from the spring and pull it out of the casing.
To remove the batteries, first open the logger and remove
the battery carousel. The batteries can easily be slid out of
the carousel.
When inserting new batteries, ensure that they are correctly
oriented; the yellow "+" markings at the end of the battery
carousel indicate the direction towards which the positive
terminal of the battery should be placed. The logger will not
work if the batteries have been inserted improperly.
To remove the battery, first open the
held within its casing by the force of a single spring. Press
firmly upon the negative end of the battery farthest from the
spring and pull it out of the casing.
When inserting a new battery, ensure that it is correctly
oriented. The positive terminal of the battery should be
placed toward the spring; the "+" marking on the bottom of
DL123A RL123A
logger.
logger.
5
Varta
CR123A CR123A
The batteries
The battery is