Metabo RB 18 LTX 60 Original Instruction page 12

en ENGLISH
- The electronic signal display (5) flashes and
the machine does not start. The restart protec-
tion is active. The machine will not start if the
battery pack is inserted while the machine is on.
Switch the machine off and on again.
10. Accessories
Use only genuine Metabo accessories.
Use only accessories that fulfil the requirements
and specifications listed in these operating instruc-
tions.
For a complete range of accessories, see
www.metabo.com or the main catalogue.
11. Repairs
Repairs to electrical tools must be carried out
by qualified electricians ONLY!
If you have Metabo electrical tools that require
repairs, please contact your Metabo service centre.
For addresses see www.metabo.com.
You can download spare parts lists from
www.metabo.com.
12. Environmental Protection
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Guideline 2002/
96/EC on used electronic and electric equipment
and its implementation in national legal systems,
used power tools must be collected separately and
handed in for environmentally compatible recycling.
Special instructions for cordless machines:
Battery packs must not be disposed of with regular
waste. Return faulty or used battery packs to your
Metabo dealer!
Do not allow battery packs to come into contact with
water!
Before disposal, discharge the battery pack in the
power tool. Prevent the contacts from short-
circuiting (e. g. by protecting them with adhesive
tape).
13. Technical specifications
Explanatory notes on the specifications on page 4.
Changes due to technological progress reserved.
U = Voltage of battery pack
P = Nominal power input
1
P = Power output
2
B = Sanding belt width
B
B = Sanding belt length
L
D = Machinable tube diameter
U = max. angle of contact
a, max.
v = Belt speed in idling
0
m = Weight with smallest battery pack/weight
without cord
12
Measured values determined in conformity with
EN 60745.
Direct current (cordless machines)
~
Alternating current (mains powered machines)
Machine in protection class II (mains powered
machines)
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
RBE 9-60: Energy-rich, high-frequency interference
can cause fluctuations in speed. However, the
fluctuations disappear as soon as the interference
fades away.
Emission values
Using these values, you can estimate the
emissions from this power tool and compare these
with the values emitted by other power tools. The
actual values may be higher or lower, depending on
the particular application and the condition of the
tool or power tool. In estimating the values, you
should also include work breaks and periods of low
use. Based on the estimated emission values,
specify protective measures for the user - for
example, any organisational steps that must be put
in place.
Vibration total value (vector sum of three directions)
determined in accordance with EN 60745:
a = Vibration emission value
h
(surface grinding)
K = Uncertainty (vibration)
h
Typical A-effective perceived sound levels::
L = Sound pressure level
pA
L = Acoustic power level
WA
K , K = Uncertainty
pA WA
During operation the noise level can exceed
80 dB(A).
Wear ear protectors!