Maintenance And Care - novaer INUK 2.6 C01 Operation Manual

(7) TEMPERATURE DISPLAY AND ERROR
Issue Reason
H8 Water tank is full.
F1 Temperature sensor
defecti ve.
F2 Temperaturfühler am
Verdampfer defekt.
F0 Loss of refrigerant. Air
conditi oning out of order.
H3 Overcurrent protecti on
of the compressor.
E8 Overload protecti on.
F4 Short circuit on the
external temperature
sensor
The temperature and error display only lights up in COOL mode. It cannot be switched on in DRY and FAN.
SAFETY FEATURES
LOCK THE REMOTE CONTROL
Simultaneously press the „+" and „-" butt ons to lock the remote control.
The "Lock" symbol lights up on the remote control and the remote control is no longer acti ve.
Display °C or °F
Simultaneously press the "-" and "MODE" butt ons to switch between °C and °F.
LIGHT FUNCTION
Press the „+" and „FAN" butt ons simultaneously for 3 seconds to switch the lighti ng on or off .
CAUTION! Remove the plug from the socket before starti ng any cleaning or maintenance work.
1. Cleaning the air fi lter
The air fi lter must be checked every two weeks of opera-
ti on. Use with dirty or clogged fi lters will always impair
the performance of the device and can also cause serious
interference.
To remove the fi lter, loosen the rear grille and then gently
pull the fi lter out to the side.
Use a vacuum cleaner to vacuum the dust. If this is not
suffi cient, wash the fi lter with lukewarm water and, if
necessary, neutral detergent; rinse with cold water and
let dry naturally before using again. Close the grille aft er
reinserti ng the fi lter; You can now start up your air condi-
ti oner again.
34
Support
Empty containers.
If the problem persists, contact a certi fi ed specialist.
Contact a certi fi ed specialist company.
Contact a certi fi ed specialist company.
Contact a certi fi ed specialist company.
The temperature is over the operati ng range of the unit (over 35 C°) or the
humidity is too high.
Wait unti l the temperature drops below 35 ° C. Check whether the evapora-
tor and compressor are blocked by some objects. Disconnect the device from
the power supply. Remove objects. Then clean the venti lati on grilles and
reconnect the device. If the problem persists, contact a certi fi ed specialist.
Contact a certi fi ed specialist company.

MAINTENANCE AND CARE