novaer INUK 2.6 C01 Operation Manual page 26

Place the air conditi oner in a verti cal positi on on a fl at and stable surface, as close as possible to a window.
Maintain a minimum distance of 50 cm from the wall or other nearby obstacles..
INSTALLATION OF THE POWER CORD HOLDER
Hook
Hook
Mount the hooks of the cable holder on the back of the
device using the screws; note the directi ons shown in the
illustrati on.
The hooks must be placed in opposite directi ons.
USE OF THE UNIT WITH WINDOW TERMINAL
Connect the fl at connector and the hose to each other,
pull out the hose enough to reach the outdoors, and then
connect it to the rear of the air conditi oner.
Connect the end of the hose to the round window connec-
ti on (1) and then connect it to the end connecti on for the
window (2), before connecti ng parts A and B.
26
A 1 A
2
The cable should be rolled up when not in use.
Push the fl at connector from top to bott om into the slots
(A) and fasten it with the hook (B). The side of the connec-
ti on pointi ng upwards is marked with the inscripti on TOP.
B
A
Open the window and lock one of the two casements with
the handle. Place the end connecti on on the fi xed wing
and lean on the other wing.
TOP