Advertisement
Note:
o When installing into drywall or concrete block, use expansion sets to ensure a firm grip.
o It is prudent to confirm that the mounting bracket location on the wall or ceiling is appropriate (i.e. provides
adequate clearances between assembled exit sign and other objects, such as walls, ceiling, or swinging doors) by
holding the assembled exit sign in the mounting bracket and holding the bracket in the desired location on the
wall or ceiling. All clearances should then be confirmed as acceptable prior to the mounting bracket being fixed
to the wall or ceiling.
o After installation is complete, the visibility of the sign from all potential viewing angles and distances should be
confirmed.
INSTALLATION
One-Sided Wall Mount Installation
The photoluminescent exit sign shall be placed above doors through which occupants must
pass to complete the exit path.
1. Mark pilot hole locations on wall using
mounting holes in the back plate.
2. Drill pilot holes in wall surface.
3. Level and mount back plate to wall using
mounting hardware.
4. Insert frame screws through mounting holes
into pilot holes in wall and tighten.
5. Snap exit face plate to back plate.
6. Attach plastic filler strips (top and sides).
7. Apply right and/or left arrows to face of sign.
Installation, Operation & Maintenance
Lume-A-Lite™ EXIT SIGNS
Model(s): BEM-SLE100/BEM-SE100
©2020 Babcock-Davis, Inc.
2
Rev 8/2020
Advertisement
