Chapter 1 Replacing the Front Bezel Single Phase UPS Unit
Tools required
#10T Torx screwdriver
•
Small fat-head screwdriver
•
Disassembling the LCD Display Bezel
1.
Start by grasping the top and bottom portion of the center plastic part of the bezel that
encompasses the LCD, and pulling it away from the front of the unit
2.
Use the 10T Torx screwdriver to remove the two screws on the left of the display. Take
care not to misplace the screws
3.
Gently pull the left side of the front panel bezel to the left to expose the screws on the
right side of the display. The two screws on the top and bottom right-hand side become
visible
Replacing the UPS Front Bezel including LCD
3