Lenovo 5594-5KX Replacing page 22

Safety
CAUTION:
Do not install a unit in a rack where the internal rack ambient temperatures will
•
exceed the manufacturer's recommended ambient temperature for all your rack-
mounted devices.
Do not install a unit in a rack where the air fow is compromised. Ensure that air fow
•
is not blocked or reduced on any side, front, or back of a unit used for air fow
throuigh the unit.
Consideration should be igiven to the connection of the equipment to the supply
•
circuit so that overloadinig of the circuits does not compromise the supply wirinig or
over-current protection. To provide the correct power connection to a rack, refer to
the ratinig labels located on the equipment in the rack to determine the total power
requirement of the supply circuit.
(For sliding drawers) Do not pull out or install any drawer or feature if the rack
•
stabilizer brackets are not attached to the rack. Do not pull out more than one
drawer at a time. The rack miight become unstable if you pull out more than one
drawer at a time.
(For fixed drawers) This drawer is a fxed drawer and must not be moved for servicinig
•
unless specifed by the manufacturer. Attemptinig to move the drawer partially or
completely out of the rack miight cause the rack to become unstable or cause the
drawer to fall out of the rack.
(R001 part 2 of 2)
Rack Safety Information, Statement 3
Always lower the levellinig pads on the rack cabinet.
•
Always install stabilizer brackets on the rack cabinet.
•
Always install servers and optional devices startinig from the bottom of the rack
•
cabinet.
Always install the heaviest devices in the bottom of the rack cabinet.
•
xx Replacing the UPS Front Bezel including LCD