Honda HHTE38BE Owner's Manual page 30

9. Holding the spool and spool retainer, grasp one end of the line and pull it
EN
to release the line from the notch in the eyelet. Repeat with the other end
(Fig. 23).
23
10. With the spool base facing
downward, align the slots in the
spool retainer with the tabs on the
spool base and press the retainer
evenly down until it snaps into place
(Fig. 24).
NOTICE:
Make sure that the tabs on the
spool base snap into place or the spool
will come out during operation.
Install a pre-wound spool
WARNING:
the tool before servicing, cleaning, changing attachments or removing material from
the unit.
1. Press the release tabs on the spool base and remove the retainer by pulling it
straight out (Fig. 18).
2. Remove the spool. Use a clean cloth to clean the inner surface of the spool
retainer and spool base.
3. Check the spool retainer, spool and spool base for wear. If necessary, replace
the wear parts.
4. Place a pre-wound spool on the spool retainer.
30
EN
CORDLESS LAWN TRIMMER — HHTE38BE
To prevent serious personal injury, remove the battery pack from
24
Tab
Slot