Setting The Time Zone; Setting Alarm Time - Grundig Sonoclock 790 DCF Manual

SETTINGS

Setting the time zone

If you use the device outside of the Central European Time Zone (CET), you
can correct the time by +/– 2 hours.
1
Press »TIME
– Display: »
2 Set the time zone with »HOUR/VOL+« or »MIN/VOL-« (Scale: »
» «, » «, »
01 02
– Display: e.g. »
Note:
If a back-up battery has not been inserted, the time is automatically reset
by DCF time synchronisation as long as the DCF reception is strong
enough. Alarm time and time zone synchronisation are each reset to
the values »
wakened at the wrong time.

Setting alarm time 1

1 Press »SET« twice.
– Display: the last alarm time set,
2
Press »HOUR/VOL+« briefly to set the hours step-by-step or hold down
to run through the hours continuously.
3
Press »MIN/VOL-« briefly to set the minutes step-by-step or hold down
to run through the minutes continuously.
– The device saves the set alarm time automatically after 10 seconds.
»AL 1
– Display:
– The device wakes you up at the set time with the alarm signal of your
choice.
________________________________________
ZONE/WEC« keep pressed for approximately 2 seconds.
«, » « flashes.
00 :
« and » «).
-02 -01
«.
02
« and » «. Please note that, in this case, you may be
00:00 00
« lights up, this means the alarm is activated.
»AL 1 « and »
00
:
« flash alternately.
ENGLISH 23
«,