Toto NEOREST MS990CGR Installation Instructions

H06658
Be sure to read the following installation instructions and install the product only as described in this manual.
1 Always Follow This Precaution
Before installing the NEOREST, be sure to read the safety instructions
in "Always Follow This Precaution" and install the product only as
described in the instructions.
4Precautionary symbols are used in these instructions to
ensure safe and proper installation of the product and to
prevent injury to the end-user and damage to personal
property. The definitions of these precautionary symbols
are as follows.
Symbol Definition
When this symbol appears,
precaution should be taken to
ensure proper and safe use of
WARNING
the product. Ignoring this
precaution could result in injury
or damage to personal property.
Avoid direct impact to the ceramic components as this will break the
ceramic and could result in injury or property damage due to water
leakage.
Always use the provided or designated parts for the installation
process.
3 Before Installing the NEOREST
■ Confirm that there is enough floor space to install the toilet unit and that the bathroom
door will open/close without obstruction.
■ Confirm that the position of the drain hole and pipes are properly lined up as
designated in the drawing.
5
Closet flange
■ Water Pressure.
The NEOREST is designed to operate under a minimum working pressure of 10 psi
flowing (as detected by a sensor within the unit). It should be noted that the standard
range of working pressures allowed by model codes is 20 to 80 psi static.*
It is necessary to install the water supply valve (angle stop) provided with the NEOREST.
This will assure the proper flow rate is achieved and allow for optimum performance of the unit.
*See warranty for details.
Optional:
How to check the water pressure:
If a pressure gauge is unavailable, the fill method
may be used as follows.
(Measuring Procedure)
NEOREST water
supply valve fully
open condition
Allow the water to
flow into the bucket
for 10 seconds and
measure the water volume.
NEOREST Installation Instructions <Bowl>
The installation of the toilet bowl for the NEOREST differs from installation of conventional toilet bowls.
4There are two types of precautionary symbols.
The symbols and definitions appear below.
The 3 symbol indicates a prohibited
use of the product.
This symbol means "Always follow
this precaution".
WARNING
Drain R1/2
11 3 "
／
4
(300mm)
7 " (150mm)
／
8
12" (305mm)
Line designating the center of the
toilet bowl
The following water volume will ensure
sufficient water pressure.
Water volume (for 10 sec)
1.5 Gallons (5.5 L) or more
NEOREST water supply valve
fully open condition
Prepare two buckets to
hold the water.
2 Parts Included in the Installation Kit
✲ Before installation, confirm that the parts listed below are included in the kit.
Part Name
Toilet
Outlet connection
Mounting Blocks
Self- tapping screws
Mounting Pieces
(for Mounting Blocks)
Washers
Self- tapping screws
Bag of screws 1
(for outlet connection)
Bolts
Bag of screws 2
Washers
Gasket
Bag of screws 3
Pan head screws
Screw caps
Paper installation template
Installation instructions
Water shutoff valve
Installation position
17 5 "
／
32
(436mm)
11 3 "
／
4
(300mm)
At least 1 foot (325mm)
32 7
／
7
5 " (150mm)
／
8
12" (305mm)
Drain pipe installation position
Quantity Drawing
1 unit
1
2
4
4
4
2
2
2
2
2
1
1
1
5 7 " (150mm)
／
8
Bathroom
door
" (835mm)
8
2003.7