InCarTec 50-953 Installation Instructions

For kia sorento

• A) Radio trim panel • B) Radio brackets

Kia Sorento

Without 7-inch touchscreen

KIT FEATURES

• ISO DDIN radio provision

• Painted scratch resistant black

50-953

I N S TA L L AT I O N I N S T R U C T I O N S

TABLE OF CONTENTS

Dash Disassembly ..................................................2

Kit Preparation .......................................................2

Kit Assembly ..........................................................3

• Panel removal tool • Phillips screwdriver

• 10mm socket wrench • Cutting tool

Table of Contents

Do you have a question about the 50-953 and is the answer not in the manual?

Page 1 50-953 I N S TA L L AT I O N I N S T R U C T I O N S Kia Sorento TABLE OF CONTENTS Dash Disassembly ..........2 Without 7-inch touchscreen Kit Preparation ............2 Kit Assembly ............3 KIT FEATURES •...
Page 2 DASH DISASSEMBLY KIT PREPARATION 1. Unclip and remove the factory radio trim 1. Cut the marked area in the dash cavity. 3. Snap the radio trim panel into the factory panel including the a/c vents. (Figure A) (Figure A) trim bezel from the back side of the bezel. 2.
Page 3 KIT ASSEMBLY 1. Secure the radio brackets to the radio using the screws supplied with the radio. (Figure A) 2. Locate the factory wiring harness and antenna connector in the dash and complete all necessary connections to the radio. Test the radio for proper operation. 3.