Advertisement
27-571 - CAMERA INPUT INTERFACE FOR BMW WITH NBT IDRIVE
CONNECTION DIAGRAM
IMPORTANT- ON AUTOMATIC CARS
If the pink wire does not give 12v output when engaging
reverse, then connect this wire to a 12V ACC switched
feed and then use the RED wire on the interface to
power the camera
ON MANUAL CARS
To activate the screen switch using the orange wire, pins
4,5,6,7,8 should be OFF,OFF,OFF,OFF,ON
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for InCarTec 27-571
Summary of Contents for InCarTec 27-571
- Page 1 27-571 - CAMERA INPUT INTERFACE FOR BMW WITH NBT IDRIVE CONNECTION DIAGRAM IMPORTANT- ON AUTOMATIC CARS If the pink wire does not give 12v output when engaging reverse, then connect this wire to a 12V ACC switched feed and then use the RED wire on the interface to...
- Page 2 27-571 - CAMERA INPUT INTERFACE FOR BMW WITH NBT IDRIVE DIP SWITCH SETTINGS Please disconnect & reconnect interface power after changing any DIP setting 4-8 Switch Setting summary *Please note that DIP Switch 5 and DIP Switch 8 put ON (▼) with...
- Page 3 27-571 - CAMERA INPUT INTERFACE FOR BMW WITH NBT IDRIVE INSTALLATION GUIDE Please ensure the car is switched off to avoid damaging the interface/ vehicle STEP ONE Using a panel tool or similar, carefully prize up the air conditioning panel in the highlighted positions.
- Page 4 27-571 - CAMERA INPUT INTERFACE FOR BMW WITH NBT IDRIVE STEP THREE Remove the screws in the highlighted positions and pull out the head unit Please note: If the original quadlock has fibre optic cables, you will need to move these to the new quadlock connector.
Need help?
Do you have a question about the 27-571 and is the answer not in the manual?
Questions and answers