BMW F 800 ST 2007 Rider's Manual page 99

Remove the front-wheel
stand.
Slip the brake calipers onto
the brake discs.
with OE Anti-lock braking
system (ABS):
The cable of the ABS
sensor could chafe
through if it comes into
contact with the brake disc.
Make sure that the ABS
sensor cable is routed snugly
along the front suspension.
Route ABS sensor cable 2
as illustrated here.
Install securing screws 1.
Brake calipers to
slider tube
30 Nm
Remove the adhesive tape
from the wheel rim.
Operate the brake several
times until the brake pads
are bedded.
Remove the rear-wheel
stand, if installed.
Remove the rear wheel
Place the motorcycle on an
auxiliary stand; BMW Motor-
rad recommends the BMW
Motorrad rear-wheel stand.
Fit the rear-wheel stand
( 101)
with OE Centre stand:
Place the motorcycle on its
centre stand.
Slacken screw 1 on the si-
lencer.
Do not remove the sealing
grease from the clamp.
Place a suitable support
(e.g. wooden block) under-
neath the exhaust manifold
to take its weight.
7
97
z