BMW F 800 ST 2007 Rider's Manual page 66

with the BMW Motorrad
5
ABS optional extra:
ABS warning light
64
Phase 2
General warning light
changes from yellow to
red.
Phase 3
z
The rev. counter and
speedometer needles both
swing back to rest. At the
same time, all the warning
lights and telltale lights
switched on in the initial
phase are switched off in
reverse sequence. The
warning light for the engine oil
pressure does not go out until
the engine has been started
and the requisite engine oil
pressure has built up.
If a needle did not move or if
a warning light or telltale light
did not show as specified
above:
Some malfunctions can-
not be indicated if one
of the warning lights fails to
show.
Make sure that all the warning
and telltale lights come on in
the pre-ride check.
Have the fault rectified as
quickly as possible by a
specialist workshop, prefer-
ably an authorised BMW
Motorrad dealer.
ABS self-diagnosis
BMW Motorrad ABS performs
self-diagnosis to ensure its
operability. Self-diagnosis is
performed automatically when
you switch on the ignition.
The motorcycle has to move
forward a few metres for the
wheel sensors to be tested.
Phase 1
Test of the diagnosis-com-
patible system components
with the motorcycle at a
standstill.
ABS warning light
flashes.
Phase 2
Test of the wheel sensors
as the motorcycle pulls
away from rest.
ABS warning light
flashes.
OE
ABS self-diagnosis
completed
The ABS warning light goes
out.
If an indicator showing an
ABS fault appears when ABS
self-diagnosis completes: