Parameters Menu - Focustronic Mastertonic User Manual

15
buttons "Nutrients" , "Build elements" you will see
summarising graphs concerning all the parameters your
Focustronic system has measured.
In same page you also always see the values of the latest
measurements concerning all parameters your device/s
has measured.
At the bottom of the Dashboard you see the device list,
where you access all the units in more detail.

Parameters menu

You have now chosen the Mastertronic from the device list
from the Dashboard. Then you are directed to a main
menu that concerns general settings like calibration and
maintenance. From this menu you now click on
"parameters", and choose one desired parameter to set
up, hereby entering the heart of the app, the parameters
menu.
There is one parameter menu for each parameter, so
all settings here are only valid for the chosen
parameter.
Graph/Latest measurement/Table history
At the top of this menu you see the results in a graphic
form, latest measured value, time for upcoming next test,
and its also possible to open a table/history to see the
details.
Extra measurement
When clicking on this you start an extra measurement of
the chosen parameter, outside the scheduled ones.
Schedule
Here you customize the schedule when you want a
parameter to be measured. When doing a schedule you
can measure the parameters in all possible orders. But
despite this, we advice to avoid to do the PO immediately
4
after a NO /NO If you want to do PO and NO /NO after
3 2. 4 3 2
each other, always do that in order: PO -NO /NO
4 3 2.