Advertisement
1. Switch the vehicle ignition "on" and the radio "on" (radio frequency or disc track number will be shown on the display panel).
2. Press and hold the Time/Frequency Display Selector button
colon ( : ) flashing. Release the Time/Frequency button.
3. Press the Down Tuning button (
minutes to the correct time.
4. When the correct time is shown on the display panel, release the Time/Frequency Selector button again or wait 5 seconds for
the display to return to the normal indication.
If a problem should develop while operating the CD player, the following error codes may be displayed on the display panel:
ER-2:
Indicates the disc is not loading properly. Try re-loading or pressing the Eject button. Check the condition of the
disc in use or try another disc.
ER-3:
Indicates the disc is not ejecting properly. Try pressing the Eject button again. Check the condition of the disc
in use or try another disc.
ER-4:
Indicates an error in the laser reading the disc. Eject the disc, make sure it is clean, undamaged, and loaded
correctly (label side up). Re-load the disc and check for proper operation or try another disc.
ER-5:
Indicates excessive temperature conditions. CD play will resume when the temperature returns to the normal
range.
ER-6:
Indicates a mechanism error. Eject the disc and try re-loading. Also try activating the Re-Set button
again.
ER-7:
Indicates an error in the laser reading the disc. Eject the disc, make sure it is clean, undamaged, and loaded
correctly (label side up. Re-load thedisc and check for proper operation or try another disc.
ER-8:
Indicates an error in the laser reading the disc. Eject the disc, make sure it is clean, undamaged, and loaded
correctly (label side up). Re-load the disc and check for proper operation or try another disc.
If the suggested measures do not solve the problem, contact an approved warranty station near you for further assistance.
SET
SETT T T T T ING THE CLOCK
SET
ING THE CLOCK
ING THE CLOCK
SET
SET
ING THE CLOCK
ING THE CLOCK
cs
approximately 2 seconds until the time display appears with the
) to adjust the hours and the "AM" indicator and the Up Tuning button (
ERR
ERR
OR CODES
OR CODES
ERR
ERR
ERROR CODES
OR CODES
OR CODES
7-
) to adjust the
cu
and try
Advertisement
