Advertisement
MANUAL UP/DOWN TUNING (
AUTOMATIC SEEK TUNING
Each time the Up Tuning button (
tune one frequency step higher. Similarly, each press of the Down
Tuning button (
) will tune one frequency step lower. To
manually tune in a station, press the button in the appropriate
direction until the desired frequency is reached.
Pressing either button for longer than 0.5 seconds and then
releasing will activate the Automatic Seek Tuning function in the
selected direction. The radio will seek the next available station and
stop on that frequency. The Seek function can be stopped by
pressing the button again or activating any other tuning function.
Pressing and holding either button for longer than 0.5 seconds
will cause the radio to continue tuning rapidly in the selected
direction until the button is released at which point it will seek
the next available station.
AUTO-STORE TUNING (AS)
PRE-SET SCAN TUNING (PS)
Press this button momentarily to scan the 6 stations in the
pre-set memories of the band in use. The unit will stop at each
pre-set station for 5 seconds before continuing to the next pre-set
station (the frequency on the display panel will flash during Pre-Set
Scan operation). Press the button again momentarily to stop
Pre-Set Scan operation and remain on the selected frequency.
Pressing the button for longer than 2 seconds will activate the
Auto-Store Tuning feature. The radio will automatically scan the
band in use and enter strong stations into the pre-set local
memory positions for that band. This function is indicated by
a momentary LOC indication on the display panel. If you have
already set the pre-set memories of that band to your favorite
stations, activating the Auto-Store Tuning feature will erase those
/
)
stations and enter the new strong stations. This feature is most
useful when traveling in a new area where you are not familiar
) is pressed, the radio will
with the local stations.
To set any of the 6 pre-set memory buttons, use the following
procedure:
During FM radio operation, this button is used to select mono or
stereo reception of the broadcast signal. Under normal reception
conditions, the unit should be left in the stereo mode, as indicated
by
signal. If the stereo signal is too weak for comfortable listening,
press the button to switch to mono reception (the
from the display panel and MON will appear). To return to the
stereo reception mode, press the button again so that the MON
indication disappears and the
The Liquid Crystal Display (LCD) panel displays the frequency,
time, and activated functions.
-3-
STATION PRE-SET MEMORIES
1. Turn the unit on and select the desired band.
2.Select the first station to be pre-set using the Manual Up/Down
or Automatic Up/Down Seek Tuning functions
3.Press the pre-set button to be set and continue to hold the
button in. A confirming tone will be heard and the pre-set number
will appear on the display panel. The station is now set into
the memory of that pre-set button and can be re-called at any
time by momentarily pressing that button.
4.Repeat the above procedure for theremaining 5 pre-sets on
the band in use and for the other 4 bands of the unit.
FM MONO/STEREO SELECTOR (MONO)
on the display panel when listening to an FM stereo
LIQUID CRYSTAL DISPLAY PANEL
bm
.
will disappear
indication returns.
Advertisement
