Advertisement
Flush both water supplies through the shower arm(2, not provided)
for one minute before the shower head(1) is installed. Apply tape or
sealant to the exposed end of the shower arm. Tighten the shower
head with a strap wrench.
Before installation, install restrictor(3) if needed. For 16344, 10115
and 16358 for Thailand & Australia, put the restrictor into the
shower head as the figure shown. For 10114 and 10117 for
Thailand, take out washer and install restrictor(3) as the figure
shown, reinstall washer.
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with
clean soft cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc.
which could adversely affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
1069894-2A-B
2
1
2
3
1
Advertisement
