Hunter Hydrawise PRO-C Software/App Owner's Manual page 5

Irrigation controllers

Hide thumbs Also See for Hydrawise PRO-C:

1. From the main menu, tap on Settings.

2. Tap on Offline Settings.

3. Tap on Disable Wi-Fi.

4. You will be presented with a warning dialogue. Please make sure you understand the

warning before proceeding. If you're sure that you want to go offline, tap Go Offline.

5. Now that your controller is in Offline Mode, you can configure it manually by tapping

on Program Start Times.

6. From this screen, you can manually configure each zone according to your desired

schedule. Simply tap on Add to add a program start time and follow the steps below.

You can toggle between zones by tapping on Next/Previous or you can leave the start

time to APPLY to ALL ZONES.

Applying the start time to ALL ZONES will run through all zones with a

single start time.

Tap ADD in the start times menu.

Select the green box upper in left to enter PROGRAM START TIME (24 hr format)

Tap the DAYS to be selected after finished with start time entry.

Tap CONFIRM to save the start time entry.

Add a second start time for all zones or single zone if desired.

Tap the HOME icon (upper right) to allow station run times setup.

NOTE: Each zone can have up to four program start times and an additional four start

times under the All Zones section as shown below.

From the home screen, you can manually configure each zone run time.

Simply tap on ZONES to add a zone run time and follow the steps below.

You can toggle between zones by tapping on each zone number.

Tap ZONES in the home menu.

Tap the first zone to edit, (For Example: ZONE 1).

Tap on RUN TIME in the center of the screen.

Enter RUN TIME (minutes:seconds format), then press OK to save entry.

Repeat steps 1-4 for station run times.

Table of Contents