Scr Dual Display / Lnb Drift; Lnb/Cable Test - Horizon Fitness HD-S2 User Manual

SCR Dual Display
The HD-S2 has a SCR dual display capability which will be enabled by settings released to
the HD-S2 download web site at a later date.
As manufacturers will be releasing various combinations of SCR LNB assemblies, downloads
suitable for these requirements will be made available via the www.horizonhge.com web site.
LNB Drift
VL Measat3
Min +0.880
Drift +0.880MHz
Max +0882

LNB/Cable Test

The LNB / Cable test is a quick function to check for possible fault conditions and will indicate if there is a problem.
LNB / Cable test
Please wait...
◄Exit
Note: The above function is for indicative purposes only and will not be suitable for SCR (Single Cable
Router) type systems. This feature tests for an open or short circuit in the cable or LNB and checks RF level
with the LNB powered and not powered. It may not indicate 'Fault' if a problem is otherwise related.
Additional feature:
If power is applied externally to the LNB then the LNB / Cable test will
not go ahead. Instead, the voltage on the line is displayed on screen.
tp1
The LNB drift function illustrated on the left here will indicate how much the
LNB Local Oscillator is offset against the calculated center ferquency after
down-conversion to L-Band. Excessive drift (greater than 3 MHz would
indicate that there could be a problem with the LNB in use.
The test results will appear after a few
seconds as indicated in the table below.
LNB / Cable OK
LNB Fault
LNB / Cable Fault
Page 16