About These Instructions; Product Information - Viessmann VITOLIGNO 300-C Operating Instructions Manual

Vitoligno 300-C Operating

About These Instructions

Take note of all symbols and notations intended to draw attention to potential hazards or important
product information. These include "WARNING", "CAUTION", and "IMPORTANT". See below.
WARNING
Warnings draw your attention to the presence of potential
hazards or important product information.
CAUTION
Cautions draw your attention to the presence of potential
hazards or important product information.
IMPORTANT


Product Information

 Indicates an imminently hazardous situation which,
if not avoided, could result in death, serious injury or
substantial product/property damage.
 Indicates an imminently hazardous situation which,
if not avoided, may result in minor injury or product /
property damage.
 Helpful hints for installation, operation or maintenance
which pertain to the product.
 This symbol indicates to note additional information
 This symbol indicates that other instructions must be
referenced.
The Viessmann Vitoligno 300-C boiler series is CSA
certified for Canada, is constructed in compliance with
CSA B51 Standard and carries Canadian Registration
Numbers. The boiler is suitable for a maximum operating
pressure of 45 psig and a maximum boiler water
temperature of 230°F (110°C).
The Vitoligno 300-C boiler must only be installed in closed
loop hot water heating systems using a pre-charged
membrane expansion tank.
Intended use presupposes that a fixed installation in
conjunction with permissible, system-specific components
has been carried out.
Commercial or industrial usage for a purpose other than
heating the building or DHW shall be deemed inappropriate.
Any usage beyond this must be approved by the
manufacturer in each individual case.
Incorrect usage or operation of the appliance (e.g. the
appliance being operated for longer periods when open)
is prohibited and will result in an exclusion of liability.
Incorrect usage also occurs if the components in the
heating system are modified from their intended use
(e.g. if the flue gas and ventilation air paths are, sealed)
or if other fuels than those intended for this appliance
are used.
Introduction
7