Advertisement
AOS-44
Operations
Manual
BEFORE INSTALLATION.
1.
This system operates from 11 volts DC to 30 volts DC, negative ground
2.
Please install this system according to the instructions in this manual.
3.
Do not disassemble
the camera or the monitor.
This voids tile warranty
Disassembling the camera ~II
compromise
the waterproof seal.
..Connect
the system to an ignition switched power source. Connection to 8 battery source 'MIl reduce battery life.
-WARNING-
1.
To prevent electrical shock. DO NOT OPEN THE MONITOR CASE.
There are potentia/1y lethal voltages inside the
monitor. There are no user serviceable paris inside. If evidence of tampering is detected, the warranty will be
considered void
2.
Keep monitor away from leaking water. rain. moisture etc It is NOT waterproof. Any moisture insKie the monitor
could cause extensive damage.
3.
Use the thumbscrews
to mount the monitor to bracket
**CAUTION**
1.
DO NOT OPEN THE CAMERA CASE. This will break the camera's waterproof seal. If e~ence
of tampering is
detected, the warranty will be considered void.
2.
Do not mount the camera near the lower area of the vehicle <e.g.bumper). This reduces the view of tt1e camera
and may cause physical damage to the camera.
INSTALLATION
INSTRUCTIONS
AOC-75 CAMERA
1.
Attach camera bracket (See Fig 1} to upper por1ion of vehicle. Attachment point must be sturdy enough to support
camera and bracket.
2.
A ttach camera to bracket using 8- 32 UNC screws provided. AdJust angle as Indlca1ed In ngure 2 (Use rMrer and
bumper and
back of vehicle as a reference point.
3.
Wind deflector may be installed. This deflector is designed to reduce the build upof dust, dirt and moisture
on the camera lens (See Fig 3).
AOM-53 Monitor
1.
Attach monitor inside vehicle in a location convenient to the driver (e.g. center of dash, overhead or in dash).
2.
Use a compression
plate to attach the monitor bracket to the dash or overhead (See Fig 4).
3.
Adjust mounting angle of the monitor to allow driver to easily view the screen from all seat positions (See FIg. 5).
4.
If necessary, snap sun visor into groove on front face of monitor. Press all (4) ~es
of the visor to snap it into place.
OCA-80 cABLe
1.
The camera-to-cable
connection is waterproof.
The cable-lo-monitor
co,lnectiOI1 is not waterproof.
Be sure to
orient the cable properly.
The cylindrical end attaches to the camera. The rectangular box end attaches 10 the
monitor.
(See Fig
6)
2.
Do not run ttle OCA-80 cable over sharp edges or corners. Do not kink the cable or use period. keep the cableol
away from hot and rotating parts.
3.
Place 811 eKCess cable in convolllted tu~ng
4.
Wire tie the cable securely.
-Page
20(
14 -
Advertisement
