Installation Procedures - Audiovox Microcruise IV Installation And Owner's Manual

--
INST ALLA TION PROCEDURES
FIGURE 13
-118
A TT ACHING CABLE ASSEMBL y
TO THROTTLE
D. Ford Throttle
I. Select a Tube Clamp that fits the throttle cable.
Make sure the tabs of the Tube Clamp point
away from the carburetor or air throttle, this
will prevent the throttle from banging.
(Figure 13)
2. Attach Cable Assembly to the Eyelet
Connector .
NOTE: Use the Bead Chain Cover.
3. Put Screw ##10-32 x 112 through the holes in the
Tube Clamp. Slide the Eyelet Connector over
the Screw. Thread Nut ##10-32 onto the Screw
and tighten. (Figure 13)
4. Figure 14 is an example of a Ford Throttle
connection using the Tube Clamp.
Eo General Motors and Chnsler Throttle
Usin2 TWO BEAD CONNECTOR
I. Most General Motors vehicles and many Chrysler
vehicles can use the Two Bead Coaaector to
attach the Cable ASRmbly. (Figure 1~
Form #2756, Page 12
,~'ii
1