Table of Contents
Advertisement
5.4. Connecting Camera Cable
WARNING!
LOAD. Shut off power before connecting or
disconnecting the RECON. Permanent damage to
electronics could occur.
1. Connect the
camera cable
to the left side
receptacle
(Fig. 22).
2. Ensure NAVIC
system power
is off.
3. Connect the camera cable's power to the crawler's
auxiliary connector located on the umbilical (Fig. 23).
DO NOT DISCONNECT UNDER
Fig. 22 - Connect camera cable to the camera
Fig. 23 - Connect camera power to umbilical
PAGE 19 of 35
DW0014 Rev 00.1
Advertisement
Table of Contents
