Advertisement
SAFETY (Red Handle) CONTROL SWITCH
The control switch allows you to temporarily disable the remote starting function of
your AA-RS30CS. To disable the unit, move the red handle control switch to the off
position.
The control switch also allows you to select between 2 hour start up and 4 hour start
up when using the automatic start up timer mode. The factory preset start up time
for this mode is every 4 hours. To select between 2 or 4 hour start up timer:
1. Begin with the control switch in the on position
2. Turn the ignition switch on then off
3. Within 10 seconds, move the control switch off, on, off, on (2 switch cycles) to
select a 2 hour start timer. After 10 seconds expire, the parking lights will
flash 2 times confirming that the two hour start cycle is set. Or, within 10
seconds move the control switch off, on, off, on, off, on, off, on (4 switch
cycles) to select a 4 hour start timer. The parking lights will flash 4 times
confirming that the 4 hour start timer is set.
REMOTE STARTING THE VEHICLE
The AA-RS30CS WILL NOT start the vehicle if any one of the following conditions
exists:
1. The Vehicle Hood Is Opened.
2. The Gear Selector Is In Any Gear Other Then Park.
3. The Brake Is Depressed.
4. The Safety Control Switch Is In The Off Position.
CAUTION! Be certain that the vehicle is outdoors before using this or any remote
vehicle starting device. A running engine produces dangerous carbon
monoxide fumes which can be harmful or fatal if prolonged exposure
occurs. DO NOT remote start the vehicle if the car is garaged.
To Remote Start The Vehicle:
Press and release channel 2 of your keychain transmitter two times within 2
seconds. The vehicle will start and remain running for the pre-programmed 10
or 15 minutes. As a visual indication, the parking lights will flash or turn on
dependent on the programming set up by your installation center.
When you arrive at your vehicle, unlock it with the key or by pressing and releasing
button 1 of your keychain transmitter. Enter the vehicle and turn the ignition key to
the on position.
CAUTION! Do not turn the key to the start position. This will cause the starter
motor to engage with the already running engine which could result in
damage. Step on the brake pedal to disengage the remote start unit.
The vehicle will continue to run but now on it's own power.
NOTE: The engine will stop running before the expiration of the pre-programmed
run timer or if you complete any of the following:
1. Press and release channel 2 of your keychain transmitter two times within
2 seconds.
2. Depress the brake pedal.
3. Open the hood.
Page 3
Advertisement
