Download Print this page

Audiovox AA-99BT2 Programming Manual page 2

Audiovox aa-99bt2 car-accessory: user guide

Advertisement

PROGRAMMING THE TRANSMITTERS
It is important to remember that during programming, each individual step
of the procedure must be executed within 15 seconds of the previous step.
When the 15 second time limit is allowed to expire, the system will
automatically terminate the programming mode. This is indicated by a
long chirp from the siren.
Additionally, the system will store codes from up to four different transmit-
ters. If a 5th transmitter is programmed to any receiver channel, then the
first transmitter programmed to that channel will be erased from the
system's memory.
To program new or additional transmitters,
1. Enter the vehicle, and turn the ignition key to the " on " position.
2. Move the program valet switch on - off - on - off - on - then off.
3. Press and hold the large transmitter button until the parking lights flash,
indicating the signal has been stored into memory.
4. If you have additional transmitters ( up to a total of 4 ) that need to be
programmed, repeat step 4 for each transmitter.
5. Flip the valet switch on then off, or turn the ignition switch off to exit the
program mode.
BATTERY REPLACEMENT:
The transmitter incorporates a small green L.E.D. built into the case. This
L.E.D. can be used to indicate battery condition. You will notice a
decrease in transmitter range as the battery condition deteriorates.
Transmitter battery replacement is recommended at least every 10 to 12
months, depending upon how frequently the transmitter is used. To
replace the battery...
1. Remove the transmitter cover by removing the
small screw from the back of the transmitter case.
2. Carefully unsnap the top cover of the transmitter
from the bottom cover.
3. Remove the discharged battery, making note of
the orientation of the + and - contacts, and dispose
of properly. Install the new (type GP23A) battery,
taking care to orient the + and - contacts properly.
4. Replace the transmitter cover, taking care not to
damage the L.E.D. or switches on the circuit
board. Reinstall the case screws.

Advertisement

loading