Advertisement
13. If you have additional transmitters ( up to 3 ) that need to be programmed,
repeat step 12 for each transmitter.
14. Flip the valet/program switch on then off.
15. The dash LED will flash four times, and the siren will chirp four times,
indicating the system is ready to accept programming for receiver channel 4.
16. Press and hold the selected transmitter button ( s ) until the siren sounds a
long chirp, indicating the signal has been stored into memory.
17. If you have additional transmitters ( up to 3 ) that need to be programmed,
repeat step 16 for each transmitter.
18. Turn the ignition key off. The siren will sound one short chirp then one long
chirp indicating the system has terminated the program mode.
NOTE: Some systems have only 2 or 3 programmable receiver channels. If
during the program steps 11 or step 15, the siren emitted short then long
chirp indicating the transmitter program mode has been exited, this
indicates you system has either 2 or 3 receiver channels.
BATTERY REPLACEMENT:
The transmitter incorporates a small LED seen through the case lens. This LED
can be used to indicate battery condition. You will notice a decrease in
transmitter range as the battery condition deteriorates. To replace the battery...
1. Remove the transmitter cover by removing the two small screw from the back
of the transmitter case.
2. Carefully unsnap the top cover of the transmitter from the bottom cover.
3. Remove the discharged battery, making note of the
orientation of the + and - contacts, and dispose of
properly. Install the new (type GP23A) battery,
taking care to orient the + and - contacts properly.
4. Replace the transmitter cover, taking care not to
damage the LED or switches on the circuit board.
Reinstall the case screws.
decrease in transmitter range as the battery
condition deteriorates. Transmitter battery
replacement is recommended at least every 10
to 12 months, depending upon how frequently the
transmitter is used.
You will notice a
Advertisement
