Westinghouse Teco E510 Instruction Manual page 99

03-11
03-12
Range
03-13
Range
03-14
Range
Output relay RY function descriptions:
03-11/03-12 =【0】: Run
Output is active when run command is ON or output frequency is greater than 0
03-11/03-12 =【1】: Fault
Output is active during fault condition.
03-11/03-12 =【2】Set Frequency within the preset range
Output is active when the output frequency falls within the frequency reference minus the frequency detection
width (03-14).
Downloaded from Dealers Industrial Equipment -- Visit
Multifunction Output Relay RY 1 functions. ( Terminals R1C,R1B, R1A )
Multifunction Output Relay RY 2 functions. ( Terminals R2B, R2A )
【0】:Run
【1】:Fault
【2】:Set Frequency within the preset range. -------------------------------( refer to 03-14)
【3】:Set Frequency reached. As set by (3-13±3-14) -------------- ( refer to 03-13/03-14)
【4】:Output Frequency Detection 1 (> 03-13) ----------( refer to 03-13)
【5】:Output Frequency Detection 2 (< 03-13) ----------( refer to 03-13)
【6】:Auto-restart
【7】:Momentary AC Power Loss---------------------------------( refer to 07-00)
【8】:Rapid Stop ( Decelerate to Stop)
【9】:Base Block Stop Mode
【10】:Motor Overload Protection (OL1)
【11】:Drive Overload Protection (OL2)
【12】:Over Torque Threshold Level (OL3)
【13】:Preset Current level Reached -------------------------( refer to 03-15/03-16)
【14】:Preset Brake Frequency Reached -----(refer to 03-17/03-18)
【15】:PID Feedback Signal Loss
【16】:Single pre-set count (3-22)
【17】:Dual pre-set count (3-22~23)
【18】:PLC status indicator (00-02)
【19】:PLC control
【20】:Zero Speed
Frequency Reached Level
【0.00~650.00】 Hz
Frequency Reached Detection Range (±)
【0.00~30.00】 Hz
https://DealersElectric.com
4-50
or call (908) 688-1966 for all of your Teco needs!