Audiovox AVT-597 Operating Instructions Manual page 7

~'&\;:
,
;\o~::; :
~~- ~
~
5.
i
~ "
~
~
~
~
6.
PICTURE SELECTOR BUTTON
Each time this button is pressed, the on screen picture adjustment display cycles through
"adjustment bars" for CONTRASl; BRIGHTNESS, COLOR and TINT. Then use VOLUME UP/DOWN
buttons to raise (,6..} or lower (T) the level. The display will automatically turn off if no adjustments
are made within about 6 seconds, or if any other button is depressed.
MUTE BUTTON
Press this button to cut off all sound. Pressing the button again restores sound to the previously set
level. MUTE may also be released by pressing the VOLUME UP/DOWN BUTTONS.
f~
VOLUME
UODDDODDODOODDDDD
7,
8
TVNIDEO BUTTON t
Any video equipment connected to the AUDIONIDEO input jacks can be used with the TV by
pressing this button.
AUTO PROGRAM BUTTON
When AUTO PROGRAM button is depressed, all channels in TV or CATV mode are searched and
tuned, and the channels with signals detected are automatically stored.
-6-
9. SKIP/SEARCH BUTTON
This button selects between SKIP and SEARCH mode. In "SKIP mode" the IV only stops on
channels that are programmed into memory when the CHANNEL UP/DOWN buttons are used. When
SKIP mode is off, the IV will stop on all active channels.
10. ERASE/WRITE BUTTON
This button is used to manually add or erase any channel that is stored in the CHANNEL UP/DOWN
memory. The stored channel numbers are displayed in "GREEN" on the screen, and the non-stored
channel numbers are in "RED".
11. TV/CATV BUTTON
Used to select regular 69 channel Broadcast TV or 125 Channel Cable IV (Standard Cable, HRC
Cable, or IRC Cable). As the button is pressed the on screen display will cycle as follows:
L TV -+- STD -+- IAC -+- HAC l