Operation - Laserworld RTI-Piko Series Manual

Manual: RTI Piko Series
6. Warnings and other notices on the device
Laser radiation!
Caution of radiation if cover is
removed. Don't look into the beam.
7. Device connections
Emission LED
key switch
connection for
power supply
power out ILDA in
240V
page 6 / 26
Laser radiation!
Avoid exposure to beam
Laser class 4
USB/LAN
Emergency stop
detachable
remote control pad
touchscreen
DMX out
ILDA out DMX in

8. Operation

Please note that when the 'Emission LED' is on, the laser is enabled and may emit laser light.
There is one LED on the remote control pad, one on the rear side and one the front side of the
device. The LED on the device lits if the device is connectect to the power supply. The LED on
the control pad lits if the device is switched on.
8.1 Power supply
Please make sure that the power supply is connected to an overload and a ground fault (earth
leakage) protection. Make sure to use correct voltage; see information at the end of this ma-
nual.
8.2 ILDA control
To control your device connect it via ILDA cables to an interface/controller. The pinout and
maximum voltages for the ILDA standard Sub-D connectors are:
Pin Signal
1 X + (horizontal)
2 Y + (vertical)
4 Interlock A
5 Red +
6 Green +
7 Blue +
13 Shutter
14 X – (horizontal)
15 Y – (vertical)
17 Interlock B
18 Red -
19 Green -
20 Blue -
25 Ground
After connecting select „LASER ON - ILDA IN" on the Remote Control Pad.
8.3 External Interlock
The Remote Control Pad has a built-in emergency stop. If there is the need for an external
interlock, please disconnect the Remote Control Pad and use the ‚Control' connection (RJ-48
connector) to connect it with an external interlock. Pins 7 and 8 are the emergency stop.
Manual: RTI Piko Series
Voltage
+ 5.0 V
+ 5.0 V
-
+ 2.5 V
+ 2.5 V
+ 2.5 V
+ 5.0 V
- 5.0 V
- 5.0 V
-
- 2.5 V
- 2.5 V
- 2.5 V
-
page 7 / 26