Advertisement
1
Preparing the Machine
No Parts Required
For Gasoline GTX Vehicles
1.
Park the machine on a level surface, set the
parking brake, shut off the engine, and remove
the key.
2.
Disconnect the negative-battery cable; refer to
your Operator's Manual.
For Electric GTX Vehicles
1.
Park the machine on a level surface, set the
parking brake, shut off the machine, and remove
the key.
2.
Disconnect the main negative-battery cable
(black) that connects the bank of batteries to
the ground point of the machine; refer to your
Operator's Manual.
2
Installing and Connecting
the Horn
Parts needed for this procedure:
1
12 V horn assembly (for Gasoline GTX vehicles)
1
48 V horn assembly (for Electric GTX vehicles)
1
Hex-head screw (5/16 x 3/4 inch)
1
Flange nut (5/16 inch)
For Gasoline GTX Vehicles
1.
Release the rubber straps on both sides of the
hood and raise the hood.
2.
Install the 12 V horn assembly to the existing
hole in the dash bracket with the hex-head
screw (5/16 x 3/4 inch) and flange nut (5/16
inch) as shown in
Figure
1.
1. Dash bracket
2. Hex-head screw (5/16 x
3/4 inch)
3.
Plug the 2 female connectors from the main wire
harness into the 2 male connectors on the 12
V horn
(Figure
1. Female connector
2
Figure 1
3. Flange nut (5/16 inch)
4. 12 V horn assembly
2).
Figure 2
2. Male connector
g034598
g034659
Advertisement
