How Install Jolly With Electrobrake - RIB Jolly 20 Manual

H
OW INSTALL JOLLY WITH ELECTROBRAKE
IMPORTANT: Before install JOLLY check that the shutter is correctly balanced by its screws mounted on the shaft. Verify it manually by
opening and closing the shutter.
Spring housing
Shaft
JOLLY 20
JOLLY 22-22 S
JOLLY 24
After have choosen JOLLY according to the dimensions of the shutter,
verify the diameter of the spring housing and of the shaft, because they
must have the same diameter of the choosen motor.
If they're different use the required adaptor:
ACJ9060 SPRING HOUSING ADAPTER Ø 220
ACJ9030 SHAFT ADAPTER Ø 42/48
ACJ9040 SHAFT ADAPTER Ø 42/60
ACJ9050 SHAFT ADAPTER Ø 48/60
A - Make the holes on the shaft as indicated on the rising above draw (see
pict. 1), open the motor and mount it as indicated in the instruction.
B - Open the pulley unscrewing the 2 screws (1).
C - Dismount the fixing flange on the shaft unscrewing the screws (2).
D - Mount JOLLY on the shaft and position the motor up and the limit
switch down (see pict. 3). Fix JOLLY on the shaft using the fixing
flange and its screws (2) and (3).
E - Reassemble the pulley and re-screw its screws (1).
F - On the last section of the shutters make a hole Ø 12 mm / 0,4 in which
allows to fix the shutter to the pulley of JOLLY using the proper screws
(4).
G - Insert the electrical cable and the releasing cable in the holes on the
shaft and execute the electrical connections (see pict. 8).
Hole diam. 12 mm / 0,4 in (entry of electric cable)
Hole Ø 12 mm / 0,4 in (in vertical) (only for the cable of the brake)
Ø 200 mm/7,8 in Ø 48 mm/1,8 in
Ø 220 mm/8,6 in Ø 60 mm/2,3 in
Ø 240 mm/9,4 in Ø 76 mm/2,9 in
=
Hole Ø 12 mm / 0,4 in (entry of the release cable)
=
45 250 200
Hole Ø 12 mm / 0,4 in (frontal-seethrough)
IMPORTANT
Respect the radius of the curve (at least 15 cm / 5,9 in)
Electrobrake
Electric Cable
1
1
Hole Ø 12 mm / 0,4 in (frontal)
=
=
Release Knob
G
B
1
2
3