Bosch Pack201HS Instruction Manual page 99

Pack201 | Maintenance | Section 6
6 Cleaning and Maintenance
6.1 General Safety Information
WARNING
Read the safety instructions
before starting any cleaning or
maintenance work.
DANGER
Lockout the main power source
with the disconnect on the door
of the electrical enclosure per
OSHA Standard 1910.147. This
precaution must be taken to avoid
the possibility of a serious shock
hazard, or an accidental cycling of
the Former which could cause a
very serious injury.
• Switch off the compressed-air.
• Open all covers and doors.
• Allow heated elements to cool
sufficiently.
CAUTION
NEVER use compressed air to clean
the machine. Always use a vacuum
cleaner or a brush. Dust could
be stuck in bearings or in gears,
increasing the risk of premature
wear.
© Bosch Packaging Technology, Inc.
All rights reserved 2012
INFORMATION
Any Cleaning or maintenance work
should only be carried out by
trained personnel.
• Do not remove parts for
cleaning unless specified in
these procedures. Unnecessary
removal of parts could result in
misalignment and subsequent
damage to the machine.
• Remove all tools and cleaning
supplies before running the
machine again.
• To prevent malfunctions and
damage to the Former, after
performing maintenance tasks,
check the equipment for correct
reassembly.
EN | 2