Bosch Pack201HS Instruction Manual page 77

Pack201 | Operator Interface | Section 4
PARAMETER
Cutting Head Circumference (mm)
Cutting Head Diameter (mm)
Cycle Stop Position (deg)
Delay NGNS
Discharge Reject Enable
Discharge Speed Ratio
Dwell Width
Feeder Enable
Feeder Speed Range (ppm)
Film Max Correction (mm)
Film Max Error Reg
Film Run Rate
Film Stop Value
Flush/Evacuation Start Speed
Flush/Evacuation Stop Speed
Gas Flush Enable
Generic 1 (or 2) # To Reject (prod)
Generic 1 (or 2) Reject Enable
Generic 1 (or 2) Reject Shifts (prod)
High Product # To Reject
High Product Reject (on/off)
High Product Reject Shifts
© Bosch Packaging Technology, Inc.
All rights reserved 2012
DEFINITION
This is the measured distance around the dwell head cam track�
(300mm) Dwell head machine only�
This is the measured distance between the center of the upper and
lower cutting head shafts� Rotary head machine only�
This is the position of the endseal crimpers when the wrapper comes to
a cycle stop�
This is the number of cycles (packages) between the No Gap No Seal
eye and the wrapper endseal crimpers�
In the ON position the discharge reject system is active� In the OFF posi-
tion the reject is disabled�
This is the ratio of the cutting head speed to the discharge conveyor
speed� Used to increase or decrease gaps between packages�
This is a value that can be added to match the crimper width to the film
speed�
In the ON position the feeder is active� In the OFF position the feeder is
disabled�
The wrapper goes to set speed minus this value when the feeder speed
eye is unblocked�
This is the maximum amount of more or less length the wrapper can
correct when the sealing material is out of registration�
This is the maximum amount that a registered package can be out of
registration without being rejected�
This is the desired film speed in packages per minute when the machine
is in film jog mode.
This value (a percentage of the package length) is used to stop the film
when the No Product No Paper eye is activated�
This is the speed the wrapper must reach before the air evacuation or
gas flush turn on.
This is the speed the wrapper must reach before the air evacuation or
gas flush turns off.
In the ON position the gas flush option is active. In the OFF position the
option is disabled�
This is the desired number of packages to reject when the reject condi-
tion is detected�
In the ON position the generic reject is active� In the OFF position the
reject is disabled�
This is the number of cycles from the generic reject eye to the reject
device�
This is the number of products to reject when a high product is detect-
ed�
In the ON position the high product reject eye is active� In the OFF posi-
tion the reject eye is disabled�
This is the number of cycles from the high product reject eye to the
reject device�
EN | 46