1�4�1 Place The Equipment - Bosch Pack201HS Instruction Manual

Pack201 | Preface | Section 1
1.4 Installation
DANGER
Although the design of this equipment
incorporates safeguards to protect
operating and maintenance personnel,
care must always be used when
operating, adjusting, and/or servicing� If
extreme care is not taken, a very serious
or fatal injury may result�
Remove the wrapper from the shipping crate and
check it carefully for any damage� If damaged, notify
the carrier immediately to file a claim. Contact Bosch
for further instructions if the damage is extensive�
Make sure all items that are listed on the packing slip
are received� Remove all packing material, chips, nails
etc� from the equipment�
1.4.1 Place the Equipment
The wrapper is shipped with crossbars for moving and
positioning� To lift the machine off of the pallet using
a fork lift, bolt the crossbars under the main section of
the frame� Position the forks under the crossbars, not
directly under the machine frame�
Check all access ways, from the shipping and receiving
dock to the installation location to ensure that they are
wide enough for the machine to pass through�
Move the wrapper and all related equipment to the
production area�
© Bosch Packaging Technology, Inc.
All rights reserved 2012
DANGER
When lifting, be sure to use a lifting de-
vice rated to handle the machine's weight
(approximately 4,000 pounds without the
infeed)�
Align the machine with the upstream and downstream
equipment and place the wrapper� Level the wrapper
by using a wrench on the flats of the adjusting legs to
turn the legs� If equipped with optional casters, make
sure that the casters are not touching the floor; the
wrapper must rest only on the adjusting legs� Remove
the crossbars�
If the Infeed conveyor was detached for shipping or
there is an automatic feeder, position and attach to
the wrapper's receiving conveyor plate� After attach-
ing, level the infeed conveyor with the adjusting legs
as with those on the wrapper�
EN | 7