Bosch Pack201HS Instruction Manual page 108

Pack201 | Maintenance | Section 6
Discharge Conveyor Section
Assembly
Conveyor
Belt tracking
Bearings and wear components
Monitoring devices.
Drive Section
Assembly
Mechanical components,
sprockets, torque limiters
Gear boxes
Bearings
Motors, encoders and cables
Electrical Section
Assembly
Terminals and components
Voltage
Servo drives
Electrical enclosure
© Bosch Packaging Technology, Inc.
All rights reserved 2012
Maintenance Check
Inspect for proper alignment and transfer from cutting head.
Inspect and adjust tension.
Inspect and lubricate.
Check for proper setup and operation.
Maintenance Check
Inspect for wear
Check for leaks. Check oil level and refill if necessary.
Check and lubricate. Perform oil change on machines with oil
bath.
Inspect for damage and for tight connections.
Maintenance Check
Inspect for damage and tight connections. Power down before
handling electrical components!
Check incoming voltage. Tune the voltage on power supplies if
necessary.
Check settings and tune if necessary.
Inspect and clean as needed.
EN | 11