Honeywell CNI4 Operating And Installation Manual page 20
Hide thumbs
Also See for CNI4:
- Operating and installation manual (82 pages) ,
- Quick start manual (8 pages)
Table of Contents
Advertisement
7 Getting Started
To setup external power supply
1. Remove the housing of the cable gland and route the power cable through it.
2. Connect the power cable to the 3-pin power connector on the Pulse Accumulator board.
3. Connect the other end of the power cable to an external power source (5V to 16V, 2A peak current).
Honeywell
| 17
Advertisement
Table of Contents
