CC Technical Documentation
Synthesizer Setup Using Phoenix
1. Open the Phone Control dialog box and put mobile terminal into Local Mode.
•
UHF: Use Rx/Tx mode in PCS and Cell band. This allows for checking power to
both Rx and Tx circuits. Typically, use channel 384 in Cell band and 600 in
PCS band.
•
Rx VHF: Use Rx mode, one band is enough.
•
Tx VHF: Use Rx/Tx mode in both PCS and Cell band
2. Use RF Main Mode dialog box to set:
•
Band
•
Channel
•
Rx/Tx mode.
Note: Be sure the "Main Mode set successfully" message appears.
Issue 2 09/2005
© 2005 Nokia Corporation
Troubleshooting - RF
Confidential
RM-11
Page 31