Cdma In-Call Testing - Nokia RM-11 Series Troubleshooting Manual

CC Technical Documentation

CDMA In-Call Testing

1. Connect the mobile terminal to a call box via an RF port (X814). (Add RF cable
loss on call box ≅0.2 dB Cell band, ≅0.4dB PCS).
2. Power up mobile terminal in Normal Mode.
3. If it is necessary, place the mobile terminal in Local Mode. Load PRL; set mobile
terminal back to Normal Mode. Make sure to set the RF channel and SID
according to the PRL.
4. Register the mobile terminal and establish a call at –65dBm call box sector
power.
• If you cannot register mobile terminal, set the sector power to –25dBm and
try again.
• If a call cannot be made in either PCS or Cell band, proceed with Local Mode
troubleshooting.
5. If the mobile terminal call is successful, open the RF menu, select AGC Status,
and click Enable Trace on the AGC Status dialog box.
Issue 2 09/2005
©2005 Nokia Corporation
Troubleshooting - RF
Confidential
RM-11
Page 15