D10241
Installation
Connecting of heaters 1800 t and 2400 t
With the heaters 1800 t and 2400 t the operating switch turns on 8V voltage, which
runs the 4430 unit, but the voltage reading on the display is incorrect (8V). It is ad-
visable to take the power for these units directly from the accumulator via a sepa-
rate fuse, in which case the reading on the display will be correct.
Shield the free cable end to
prevent short circuits
Connecting to the heater's control panel
4430
The power cable must have
at least a 1 A fuse
- 32 -
en
BATTERY
490538