Table of Contents
Advertisement
ELECTRICAL
During installation, it is important to attach a 10 AWG copper stranded wire (minimum
requirement) from the earth ground attachment point on the unit to an appropriate grounding
location for your installation.
The camera can be powered either by PoE (802.3af) (power over ethernet)or by 12VDC using LVT
connected the 2.1mm power jack.
WARNING! CSA Certified / UL Listed CLASS 2 power adaptors must be used in order to
comply with electrical safety standards. A UL certified power adaptor is included with the
unit. For permanent installation using 12VDC adaptor in Canada ensure that a CSA
certified adaptor is installed.
LENS FOCUSING
After mounting the camera, carefully remove the housing cover after loosening the set screw.
WARNING! Avoid thread damage. Never use force when removing or assembling housing cover.
Ensure that the Buna-N rubber gasket is correctly positioned at the base of the threaded flange
before reattaching the housing cover. Failure to correctly reinstall the housing cover will
compromise the sealing of the unit.
Set Screw
Correctly Positioned Buna-M Rubber Gasket
Opticom Technologies Inc.
www.opticomtech.com
www.toughestvideocamera.com
March 2016
CC03-IP2MVFIR Camera
USA Sales:
Battle Creek, Michigan:
Canada:
Head Office (Vancouver):
Installation Manual
800-578-1853
855-569-3240
Advertisement
Table of Contents
